SEBO Bag Compartment Cover ...
$24.00
Product details
Scuffs along the front edge, a cracked corner and printing that has gone chalky are what years of bag changes do to a compartment lid. Part 8005DRER is the printed red bag cover for the SEBO D4: the outer panel that swings over the dust bag and carries the machine's graphics.
It is the most handled part on the canister and the first to meet door frames, stair nosings and table legs. Once the latch points wear or the panel warps, the cover no longer pulls down tight, and a compartment that does not close cleanly lets dust escape around the seam and loses a little suction to the leak. A replacement restores both the closure and the finish, and because it uses the existing hinge hardware the swap is a straightforward one rather than a strip-down. If the hinges themselves are worn as well, they belong to the 8003DRER top casing rather than to this panel.
- Part number: 8005DRER
- Machine: SEBO D4 canister
- Colour: red, with the factory printed graphics applied
- Function: outer cover for the dust bag compartment
- Replace when: the panel is cracked or warped, the latch no longer holds, or the print has worn away
- Related: 8003DRER top casing, 8001DRER bottom casing
- Note: confirm your machine is the red D4, since each finish carries its own number
Check the latch points on the machine body while the old panel is off. If the catch on the shell is worn as well as the one on the cover, a new panel will still sit loose, and the top casing is the assembly that carries those points. Fitting a fresh cover onto sound hardware is what gives back a lid that closes with an even gap.
It fits directly in place of the panel you take off, using the existing hinge hardware, and should close flush with an even gap along the seam once seated. Anyone searching for a SEBO D4 bag cover, a red D4 dust compartment lid or a printed D-series cover is looking for 8005DRER. Ships in 2-5 business days.
