Hoover Elite Upright Switch...
$12.99
Product details
Part 28218061 is the push-button power switch used across a long line of Hoover Elite uprights and F-series carpet cleaners, mounted in the body panel exactly where your thumb lands, and it is the single point that sends power onward toward the motor.
Switches wear out mechanically well before any other part of the unit does, since every start and stop runs through the same set of contacts inside. The failure shows up in two familiar ways: press the button and get no response at all, or the vacuum runs fine until the handle gets nudged and it dies mid-pass. That second pattern, cutting out with vibration or handle movement rather than staying off, is switch contacts losing connection under load, not a motor problem. Push-button switches like this one carry the full motor current through a small set of internal contacts every time they close, and each cycle wears those contacts a little further. Pitting and carbon buildup on the contact surface is what eventually turns a solid connection into an intermittent one, long before the switch housing itself shows any outward sign of wear.
Replacing the switch is a small job compared to chasing the fault further into the machine, and it is the more common failure point whenever the motor itself still sounds and pulls the way it should.
- Part: 28218061, push-button on/off switch
- Function: carries power from the body panel switch to the motor
- Fits: Hoover C3820, F5806, F5810, F5821, F5868900, F5871900, F5883900, F5915, FH50015, FH50020, FH50021, FH50025, FH50026, FH50027, FH50028, FH50041, FH50042, FH50043, FH50044, FH50045, FH50046, FH50047, and FH50048CA
- Also listed for: a number of additional F58xx and F59xx models; verify your full model number before ordering
- Symptom it fixes: a vacuum that will not start, or that cuts out when the handle is moved
Unplug the machine before opening the switch housing, since the contacts are live whenever the cord is connected.
