Hoover WindTunnel Commercial Cord Assembly Clamp

This cord assembly clamp, part 27478456, holds the attachment hose cord against the body of the Hoover WindTunnel commercial upright, keeping it from swinging loose as the machine moves through a room. Confirmed fit is the Hoover C1701900.

Without the clamp doing its job, the cord drapes free between the wand and the body instead of running tight against the machine. In a commercial setting that means a cord dragging across wet floors right behind a mop crew, catching on chair legs mid-pass, or lying loose across a walkway where someone can trip on it between rooms. Operators notice a missing clamp almost immediately, since the cord is right there getting in the way on every push and pull of the machine.

Re-clamping it is a small fix by parts-cost standards, but it is one of the details that separates a machine that looks and runs like new from one that looks worn out after a few months of commercial service, even when everything mechanical underneath is fine.

• Part: cord assembly clamp, part 27478456
• Fits: Hoover C1701900 WindTunnel commercial upright
• Function: secures the attachment hose cord along the machine body
• Tip: seat the whole cord run inside the clamp before pressing it closed, so tension cannot pull it loose again

It takes the place of the original clamp in the same spot, so putting it on does not call for any extra hardware. If you run a related WindTunnel commercial model not listed here, check part 27478456 against your machine's part diagram before ordering, since the C1701900 is the only fit confirmed in our data.