Kenmore Mounting Rack - DS4090 Stick Vacuum

The mounting rack is the storage bracket a Kenmore DS4090 stick vacuum parks on between uses, the piece that holds the machine upright and lined up so it sits securely instead of leaning or sliding out of place. Part 571018103 is the replacement rack that fits it.

Racks like this usually need replacing after part of the bracket gives way under thousands of repeated dockings, or after the fixing points holding it in place have worked loose. Either way, the symptom is the same, a vacuum that will not sit steady in its rack anymore and starts leaning or dropping free the moment someone brushes past it in a hallway. A quick monthly check that the rack still holds firm takes seconds and catches loosening hardware before the vacuum ends up on the floor.

• Part: mounting rack, part 571018103
• Fits: Kenmore DS4090 stick vacuum
• Function: storage bracket that holds the vacuum upright and aligned when parked
• Tip: mark the old rack's fixing positions before removing it so the new one lines up in the same spot

If your rack is fixed to a wall, the wall side of the job matters as much as the rack itself: a bracket set into drywall alone, without solid backing or proper anchors, is far more likely to pull loose again even after a straightforward replacement, so it is worth reinforcing the mounting points while the old rack is down. It is made for the DS4090, so fit needs no trimming or improvising during installation. Confirm the model number on your vacuum reads DS4090 before ordering, since that is the only model this rack is listed for.