ProTeam Cuff Adapter - 1 1/4 x 1 1/4

Part 103099 is the cuff adapter built for the ProTeam 1007, measuring 1-1/4 inches across at each end. It closes a sealed gap in the airflow route linking the vacuum unit to whatever hose or tool is attached, and it is small enough to be easy to overlook when tracing down a suction problem.

A joint like this one loses suction the moment it develops even a hairline crack or a loose seat, and the effect shows up as pickup that has noticeably softened at the floor tool, even though the motor and filters remain in good shape. On a machine that has otherwise been maintained properly, tracing a suction complaint back to this single connection is usually quicker and far less expensive than opening up the motor housing to look for the cause there instead.

Getting the size right matters more than it might seem for a part this small. Measure the current fitting to confirm it also spans 1-1/4 inches on both ends, and verify the installation is going onto a ProTeam 1007 before placing an order. A snug, properly seated adapter keeps air moving cleanly through the rest of the tool chain instead of bleeding off at the very first joint, which makes it worth checking before assuming a longer hose run or a wand connection is to blame for lost suction.

• Part: 103099, cuff adapter
• Fits: ProTeam 1007
• Size: 1-1/4 inch by 1-1/4 inch, matching fittings at both ends
• Function: joins the vacuum unit to the hose or tool while sealing the airflow path
• Replace when: suction drops at the floor despite clean filters and a clear airway, and the leak traces back to this connection point