SEBO Motor Cabling for SOFTCASE CE12

Down in the CE12 base, 75118 is the length of factory loom joining the motor to the rest of the machine's electrical circuit. It is the section of loom that lives closest to the heat, which is exactly why it is offered as a service part rather than something to be spliced back together.

Insulation on a lead that spends its life beside a working motor goes hard and brittle over the years. Once it cracks, or once a previous repair has left joints, tape and stretched terminals behind, replacing the loom outright is faster and far more reliable than re-terminating what is there. Factory cabling arrives with the right connectors already terminated and cut to the length SEBO intended, and that length matters more than it sounds: a cable that is a little too long has to be tucked somewhere, and in a vacuum base that usually means against something hot or something turning.

The diagram puts the motor group in a tight cluster, with the 120 volt board at position 120, the motor bridge at 122 and the torque sensor at 124. If a machine is dead rather than intermittent, work along that group and along the supply side, where the mains cable is position 15 and the mains connector position 10.

• Part number: 75118
• Component: motor cabling loom
• Fits: SEBO SOFTCASE CE12 upright vacuum
• Why factory cabling: correct connector types and correct lead lengths
• Sold: each
• Related positions: 120 volt board at 120, motor bridge at 122, torque sensor at 124
• Genuine SEBO electrical part

Photograph the loom before it comes out; connector positions are much easier to recall from a picture than from memory.

Carry out the work with the vacuum unplugged. Typical searches are SEBO motor cabling, CE12 motor wiring harness and SOFTCASE CE12 electrical parts. Ships in 2-5 business days.