SEBO Switch Lever for ET-C Power Heads

Thousands of on and off presses wear the pivot faces on a switch lever until the click goes soft and you can no longer tell by feel whether the brush motor is running. Part 2452 is the replacement lever for the SEBO ET-C power head.

The lever is the mechanical link between a finger and the micro switch inside the head. It takes the press at one end and converts it into positive, repeatable switch travel at the other, which is why the pivot geometry matters more than the lever's strength. Once the plastic cracks or the pivot slops out, the switch either misses the actuation entirely or stays half made, and at the machine that reads as intermittent brush operation: the roller runs, then stops, then runs again when the lever is nudged a certain way. Replacing the lever restores the defined click that tells you the switch has changed state.

Alignment counts for as much as the lever itself. The micro switch is held on its datum by a molded support, listed separately as 2453, and a cracked support will make a new lever feel just as unreliable as the old one, so check both while the head is open. The complete black ET-C cover is catalogued as 2482SW if the shell is damaged too.

• Part number: 2452
• Fits: SEBO ET-C power heads
• Part supplied: switch lever only, sold singly
• Material: molded plastic lever
• Restores: a defined, repeatable click at the switch
• Check at the same time: micro switch support 2453
• Related ET-C parts: 2482SW cover, 2466 swivel neck support

Genuine SEBO part from an authorized dealer. Ships in 2-5 business days. Searches for a SEBO ET-C switch lever or an ET-C power head switch replacement both land here.