SEBO Swivel Neck Assembly for ET-1 Power Heads - Black 46 in. Cable

A brush roller that dies mid-pass, or a head that fights you on every turn, usually points at the pivot rather than the motor. Part 2362F1GS renews that whole joint in one go: the swivel housing plus the black cable, 46 in. long, already run through and terminated.

The swivel neck is the hinge that lets the cleaning head recline and follow the floor while the wand stays upright, and the low-voltage feed to the brush motor passes through the same moving joint. Flex fatigue lands on the lead first, which is why SEBO services the two together as one assembly instead of as separate items. The faults that point here are a pivot gone loose and vague, a brush that cuts in and out as the handle swings through its arc, and visible chafing where the cable leaves the neck. Any of those is worth acting on early, because a lead that has worn through its insulation does not improve with use.

Cable color and length are the whole of the ordering decision. SEBO built the ET-1 neck in more than one specification, and the alternative, carrying a light gray 36 in. lead, is 2362F2GS. SEBO's own listing ties this version to its 9942F1 ET-1 head, so measure the existing cable and check its color before choosing between the two.

• Part number: 2362F1GS
• Fits: SEBO ET-1 power heads, both the switched and the unswitched builds
• Cable supplied: black, 46 in. long, pre-fitted through the neck
• SEBO reference: the 9942F1 ET-1 head
• Supplied as: one complete neck assembly, housing and lead together
• Role: steering pivot for the head plus power routing to the brush motor
• Alternative specification: 2362F2GS with the light gray 36 in. cable

Genuine SEBO component; ships in 2-5 business days. Shoppers reach this page searching for a SEBO ET-1 swivel neck assembly, an ET-1 power head cable replacement, or a genuine SEBO neck with the long black lead, and all three describe the same part.