Wessel Werk Brush Roll - EBK340, EBK341, 13 Inch

Part 10.9011-371 is the 13 inch brush roll for the Wessel Werk EBK340 power nozzle, also listed for the EBK341. It is catalogued at 13 inches, and that figure is the one to confirm before ordering.

Fits the Wessel Werk EBK340 and EBK341. Pull the old roll and measure it end to end before ordering a replacement, since confirming the 13 inch length against your worn roll is a more reliable check than going by the nozzle model alone.

Watch for the standard wear pattern on these rolls: bristles that have flattened or gone short lose their grip on carpet pile, so the vacuum still sounds and pulls normally but leaves dirt worked down into the fibers instead of lifting it. To swap the roll, remove the bottom plate on the nozzle, lift the worn roll free of its end sockets, and seat the new one the same way before closing the plate back down.

• Part: 10.9011-371, 13 inch brush roll
• Fits: Wessel Werk EBK340, EBK341
• Length: 13 inches, measure your old roll before ordering
• Replace when: bristles are flattened or short and carpet pile stops lifting after a pass

While the bottom plate is off, check the drive belt for glazing or stretch as well, since a roll replaced on a tired belt will not spin at full speed no matter how fresh the new bristles are. If the nozzle has been in service a while, wipe the roll seats clean before dropping the new roll in, because grit packed into the sockets can hold one end high and put the roll out of true.