35' NuTone Low-Voltage Central Vacuum Bare Floor Kit w/ Wessel TK286 & 4-Pc Tools

The Wessel-Werk TK286 turbo tool anchors this 35' low-voltage NuTone central vacuum kit, paired with a 4-piece tool set for cleaning above the floor. Low-voltage hose carries a signal wire rather than full electrical current, so the handle switches the central power unit on and off directly rather than needing a separate control back at the inlet.

The TK286 is turbine driven, meaning the vacuum's own airflow spins its brush roll and there is no motor or cord in the head. Wessel-Werk builds it to a 1-1/4 inch (32mm) fitting and puts an inspection window in the top so you can watch the brush roll turn without taking the tool apart, which is the quickest way to tell a stalled turbine from a genuine loss of suction.

NuTone systems use low-voltage inlets, so confirm your home's central vacuum is wired that way before ordering, since a low-voltage hose will not power a direct-connect system and the reverse is also true. Measure the distance from your inlets to the far corners of each room as well, since 35 feet reaches most of a single level from a well-placed inlet but can fall short in a larger home.

• Hose: 35', low-voltage
• Nozzle: Wessel-Werk TK286 turbo tool, turbine driven, 1-1/4 inch (32mm), inspection window
• Tools: 4-piece set for above-floor cleaning
• Built for: NuTone central vacuum systems
• SKU: 11213TN

If cleaning performance ever seems to drop, check first that the hose and wand are seating fully at every connection point along the run, since a loose fit anywhere between the inlet and the nozzle starves an air-driven turbine and is one of the easiest causes to rule out.