Carpet Pro Front Cover Clam...
$6.99
Product details
This front cover clamp closes and secures the front cover on Carpet Pro's S100, RSQ1 and FV500 canister vacuums, part BD00261. Whatever vacuum the motor produces has to build up behind that closed cover, so the clamp is doing real structural work every time the machine runs, not just holding a panel shut.
Plastic latches like this one usually fail from repeated flexing rather than a single overload. The catch arm takes a little stress every time the cover is opened and closed, and over enough cycles a hairline crack forms at the hinge point. Once that happens, the clamp may still look whole and even click closed, but it no longer pulls the cover down tight, and the machine loses suction across the board even with a fresh bag and clean filters installed.
This listing covers the clamp only, sold apart from the cover panel it closes, so a broken latch does not require replacing the whole cover to fix. No published model breakdown ships with the listing beyond the three model names, so compare the clamp shape and its mounting screw against your machine before ordering rather than going by the model badge alone.
- Part number: BD00261
- Component: front cover latch clamp
- Application: S100, RSQ1, FV500 canister vacuums
- Sold: each
Wipe the seal the cover presses against clean of dust before reinstalling, since grit trapped under the seal can keep even a brand-new clamp from pulling the cover down fully and holding vacuum the way it should. Replacing it is a small job: remove the mounting screw or clip holding the old clamp, seat the new one in the same position, and check that the cover pulls down snug and seals evenly around its full edge before closing up the machine.
