ProTeam Machine End Pigtail...
$35.99
Product details
Every time an Alpine backpack operator bends, twists, or reaches during a route, the short stub of cord where power enters the housing absorbs that movement. Part 105790 replaces just this section, the piece technicians call the pigtail, without requiring a full cord replacement. Small as it is, this connector sees more mechanical stress across a working year than almost anything else on the unit.
Treat a cord fault here as an electrical hazard rather than a nuisance. Any visible nick, exposed copper, or slack fit where the plug meets the housing warrants immediate replacement rather than a wrap of tape as a temporary fix. A section that grows warm during normal operation, or that causes power to blink on and off, has already begun to fail even if it still technically works.
Disconnect the machine from power before starting the swap. Once the new pigtail is seated, confirm the strain relief clamps down firmly where the cord meets the housing, since that exact spot is where fatigue starts building again. The whole job takes only a few minutes with basic hand tools and returns the Alpine to full-time route duty with no downtime beyond that.
- Part: 105790, machine end pigtail
- Fits: ProTeam Alpine backpack vacuum
- Function: connects incoming power right at the point it enters the machine housing
- Replace when: the cord shows cuts or exposed wire near the machine end, or power cuts out when the cord is moved
- Safety: always unplug the machine fully before inspecting or replacing the cord section
