Rexair Rainbow E2 Power Noz...
$17.99
Product details
The wand of a Rainbow E2 sends power down to the nozzle motor through this cord, part R12903, tri-rated for the job and terminated in the snap-in socket used on the newer nozzle motor design rather than the older screw-together connector.
Cords like this fail where they flex, not where they sit still. A nozzle that hesitates or cuts out mid-swing, runs fine at one wand angle but not another, or drops out altogether, is usually hiding a break inside the insulation near the pivot or the nozzle housing, damage that shows nothing at all from the outside.
Before ordering, rule out the motor itself: spin the nozzle brush roll by hand with the belt off, and a motor that turns freely is unlikely to be the fault. If the cutout follows the wand's movement instead, tracking worse at certain angles, that pattern points at the cord rather than the connector or the motor behind it.
Rexair lists this cord for the E2 Blue and E2 Gold two-speed models, the E2 two-speed, and the one-speed Rainbow E and E2 machines. Match the plastic socket on the cord to the connector on the nozzle motor before ordering, since the snap-in design here will not mate with the older screw-together motors.
- Part: R12903
- Connector: snap-in socket, newer nozzle motor design
- Fits: Rainbow E (1 Speed), E2 (1 Speed), E2 (2 Speed), E2 Blue, E2 Gold
- Symptom: nozzle cuts out or stutters as the wand moves
- Before ordering: spin-test the nozzle motor by hand to rule out a seized motor
