ProTeam Rear Base Plate - Progen 15

Part 835681 is the rear base plate on the ProTeam ProGen 15, the section of the underside housing that sits closest to the floor and takes the abuse that comes with it: thresholds, curb edges, and being dragged across a loading dock more times than anyone counts.

Because it forms part of the structural underside, a cracked or warped base plate does more than look bad. It can let the housing above it flex out of alignment, which shows up as panels that no longer seat evenly or a machine that develops new rattles it never had when new. Catching the damage before it spreads to the surrounding housing is the main reason to replace this plate promptly rather than let it ride.

Cracks in a part like this tend to start where stress concentrates, at fastener points and molded corners, so a plate that has cracked around a mounting point can leave a screw with nothing solid to bite into even while the rest of the panel still looks intact. A close look around each fixing point is worth the extra minute during inspection.

This base plate is listed specifically for the ProGen 15; if you are not certain which ProGen model you have, check the label on the machine before ordering. A visual comparison against the old plate before installing the new one is also worth the minute it takes, since a plate that has warped rather than cracked can be harder to spot at a glance than one with an obvious break.

• Part: 835681, rear base plate
• Fits: ProTeam ProGen 15
• Function: structural underside panel at the rear of the housing
• Replace when: cracked, warped, or letting the surrounding housing flex out of alignment