Hi Reach 1-1/2" 45-Degree A...
$55.99
Product details
Angled wand sections exist because a straight wand fights you on stairs, sloped ceilings, and the underside of upper cabinets, forcing an awkward grip to keep the tool head flat against an angled surface. This Hi Reach piece, part 68602, bends 45 degrees over a 22.5-inch aluminum section sized for a 1-1/2" wand system, so the tool head follows the surface instead of the operator forcing it there.
A compression collar at the joint clamps this angled section to the straight extension wands in a Hi Reach kit, keeping the connection locked while the wand is held overhead. Hi Reach fittings and lengths vary between kits and manufacturers, so confirm the 1-1/2" cuff on this piece matches your existing wand before ordering; a mismatched diameter will not seat or lock correctly.
When an angled section like this fails, it is usually the compression collar rather than the aluminum tube itself. A joint that will not tighten fully, or a wand that rotates under light pressure, points to worn threads or a worn gasket inside the collar rather than a bent or cracked tube, and the leak that follows shows up as suction escaping at the joint instead of pulling through the tool head.
A shallow angle like this stays closer to the wand's centerline than a wider-angle section would, which keeps it steadier at full extension for the same overhead reach.
- Part: 68602
- Fit: 1-1/2" wand diameter
- Length: 22.5 inches, angled section
- Angle: 45-degree bend, for sloped and overhead surfaces
- Material: aluminum, black finish
