SEBO Power Supply Cord for ...
$31.00
Product details
A cord that only works when held at a certain angle, or one starting to fray where it leaves the machine, has stopped being an annoyance and become a hazard. Order code 5433DG covers the dark gray mains lead used on the AUTOMATIC X1, the AUTOMATIC X2 and the SEBO Duo, listed as item 9 on the Duo drawing.
On that sheet it belongs to the handle group, sitting beside the handle cable at item 3 and the switch cap with its holder at items 5 and 6 — the wiring run between the grip and the body of the machine. What arrives is a full-length lead rather than a repair section, terminated the way the factory terminated it so that it lands on the same internal connections.
Replace rather than tape when any of the following turn up: bare conductor showing anywhere along the jacket, a plug running warm or carrying scorch marks, a slice taken out by a doorway or a caster, or power that flickers as the cable is flexed. Work of this kind involves mains terminations, which suits someone confident with them or a service centre.
Route the new lead exactly as the old one ran, through every original clamp and guide. A cord pinched under a screw boss, or pulled tight where it enters the body, will fail again at that point of strain rather than lasting the life of the machine.
- Order code: 5433DG
- Machines covered: AUTOMATIC X1, AUTOMATIC X2, SEBO Duo
- Shade: dark gray
- Drawn at: item 9 on the SEBO Duo sheet
- Around it there: handle cable 3125, switch cap 3137GS, switch cap holder 3136HG, handle grip 3142HG
A genuine SEBO lead meets the original clamps and connections as it was meant to, which is what keeps this a repair rather than an adaptation.
Genuine SEBO mains lead, dispatched within 2-5 business days.
