ProTeam Power Supply Cord -...
$28.99
Product details
Part 103181 is the power supply cord running from the wall plug into a ProTeam Sierra backpack vacuum, and the Cen-Tec CT210 takes the same part. A Sierra that loses power on and off while it is strapped on is worth checking here first.
Cords like this tend to fail at their two ends rather than in the middle. At the plug, repeated pulling at an angle eventually snaps a conductor inside; at the machine, flexing against the strain relief with every pickup wears through in the same spot over time. Both faults produce the same outcome on the machine, power that comes and goes as the operator shifts position, and both point to a cord that has earned a spot on the sidelined pile until it is fixed. A nick anywhere along the length that shows bare insulation underneath tells the identical story.
Disconnect the vacuum before starting the swap, and check the entire cable for damage rather than just the two ends, since a cord dragged across job sites can pick up cuts anywhere along its run.
Once the replacement is fitted, flex it by hand near the strain relief and near the plug before returning the Sierra to work, confirming steady power through the same range of motion the cord sees in normal use. A few extra minutes spent testing here saves a callback mid-route later.
- Part: 103181, power supply cord
- Fits: ProTeam Sierra, Cen-Tec CT210
- Function: supplies wall power from the plug to the machine
- Install check: flex near the plug and strain relief before service
- Watch for: intermittent power loss, damage at either end
